Online Store

Click to enlarge

The Multimeter Clock consists of three multimeters, the first meter displays hours, the second displays minutes and the last displays seconds. A 16F628A PIC microcontroller keeps track of time and outputs a calculated current to each meter to display the current time. The meter shown above is one example of what you could make to show off your Multimeter Clock. Please note that the kit does not include the clock housing or the meters. If you have a CNC machine please see the project page for the CNC files to create your own Simpson 260 Multimeter clock case.

Details for the Multimeter Clock can be found here.

Please note that this project is advanced since you will need to construct the entire circuit based on the schematic on the project page.
 

Kit Includes:

Component	Type	Quantity
PIC Microcontroller	Pre-programmed 16F628 chip.	1
Chip Socket	18 pin	1
Circuit Board	2X3 inch perfboard	1
Terminal Block	2 positions	5
Diode	1N4401	5
12V Filter Capacitor	100uF	1
5V Filter Capacitor	47uF	1
5V Decouple Capacitor	.01uF	1
Crystal Oscillator Capacitor	22 pF	2
5V Regulator	LM7805	1
Crystal Oscillator	20 mHz	1
4.7K Ohm Resistor	1/4W	4
1K Ohm Resistors	1/4W	1
Button	Tactile	3
Pin Header	0.1 inch pin header (2 position)	2
Shorting Jumper	0.1 inch shorting jumper	2
Indicator LED	Blue LED	1

In addition to this kit what else will you need?

• A clock housing.
• Plug in power supply.
• Three analog meters.